Vantis Infinity Capsule

• Eleven modalities in one shell, each switched independently at the front panel: cell resonance, far-infrared emitters, graphene film heat, a terahertz-emitter back mat, ten-level whole-body vibration, a rotating gyromagnetic field, chromotherapy, photon light wave, a negative oxygen ion generator, ozone sanitation and Bluetooth audio.
• Graphene film heating converts electrical energy to heat at up to 99.15% efficiency and delivers it as far-infrared, so the cabin comes up in eight minutes and holds an even temperature end to end.
• Far-infrared output sits in the 6 to 14 micron band, with the jade and bian-stone mat inlay emitting at 7 to 20 micron under load.
• The gyromagnetic module runs a rotating pulsed magnetic field across the body — thousands of field lines per minute — selectable independently of the heat.
• Photon light wave panels line the lid and cover the body from shoulders to feet, alongside the chromotherapy color array.
• Vibration runs ten selectable levels through the bed platform; levels four through six are the standard operator setting for a general session.
• A negative oxygen ion generator conditions the cabin air through the session.
• An on-board ozone cycle sanitizes the empty cabin between clients in 10 to 15 minutes. Nobody may be in the room during the cycle, and the space is vented for 30 minutes afterward.
• The client's head stays outside the shell for the whole session, which makes the capsule usable by people who will not tolerate a fully enclosed sauna or a float tank.
• Bluetooth pairs to the client's own phone for music or audiobooks through the cabin speakers.
• One dedicated 120V, 20A circuit runs the entire unit. No plumbing, no drain, no fill, no ventilation duct.

Overall length

7 ft 10 in (94 in)

Overall width

3 ft 8 in (44 in)

Height, lid closed

3 ft 6 in (42 in)

Height, lid fully open

6 ft 6 in (78 in)

Net weight

550 lb

Crated shipping weight

700 lb

Crate size

100 in × 50 in × 50 in

Occupancy

Single occupant, supine, head outside the shell

Maximum occupant weight

300 lb

Maximum occupant height

6 ft 4 in

Modalities

11, individually switched

Heating

Far-infrared emitters plus graphene film panels, up to 99.15% electrical-to-thermal conversion

Far-infrared band

6 to 14 micron, with jade and bian-stone mat inlay at 7 to 20 micron

Back mat

Terahertz emitter mat with jade and bian-stone inlay

Cell resonance

Operator-selectable, front panel

Vibration

Whole-body platform, 10 selectable levels (4 to 6 standard)

Gyromagnetic

Rotating pulsed magnetic field, operator-selectable

Light

Chromotherapy color array plus photon light wave panels in the lid

Air

Negative oxygen ion generator

Sanitation

On-board ozone generator, 10 to 15 min cycle, cabin empty, room cleared and vented 30 min after

Audio

Bluetooth, pairs to the client's phone, cabin speakers

Control

Front panel with individual modality selection and session timer, plus a rear main power switch

Preheat

8 min at maximum heat setting

Session length

30 to 35 min standard, up to 40 min in cold months, 45 min maximum cabin run time

Cabin temperature

140°F standard, adjustable down to approx. 104°F for a low-temperature session

Consumables

Disposable waterproof non-woven liner per client

Booking slot

60 min including preheat, changeover and ozone cycle

Plumbing

None

1. 01Run the ozone cycle before the first client of the block — 10 to 15 minutes, cabin empty and nobody in the room, then vent for 30 minutes.
2. 02Power the unit at the red main switch on the rear of the shell.
3. 03Enable the modalities for the session: cell resonance, negative oxygen ion, vibration level, far-infrared heat, terahertz mat, graphene heat, chromotherapy and gyromagnetic.
4. 04Set far-infrared, terahertz and graphene to the maximum setting and preheat for 8 minutes. The client changes and drinks a glass of lightly salted water during preheat.
5. 05Lay a fresh disposable waterproof non-woven liner over the bed surface.
6. 06Seat the client, close the lid to the shoulders, confirm the head is clear and the temperature is comfortable, then trim the cabin to about 140°F. Keep the upper-cabin graphene setting moderate to avoid contact burns.
7. 07Set vibration between levels 4 and 6 — the standard comfortable range out of ten.
8. 08Run 30 to 35 minutes, or up to 40 minutes in cold months. Stay within earshot; the client's head is outside the shell and the lid opens from inside at any point.
9. 09End the session, remove and discard the liner, wipe the interior down.
10. 10Run the ozone cycle again for 10 to 15 minutes with the cabin empty and the room cleared, then vent for 30 minutes before the next client.

Minimum clear room

8 ft × 11 ft

Recommended room

10 ft × 12 ft

Minimum ceiling height

8 ft (lid opens to 6 ft 6 in)

Minimum door opening

36 in clear, for a 700 lb crate on a pallet

Clearance, head / control end

24 in

Clearance, entry side

36 in

Clearance, other side and foot end

14 in

Floor

Level, sealed, non-porous, rated 100 lb / sq ft

Electrical circuit

One dedicated 120V, 1-phase, 60 Hz, 20A branch circuit, GFCI, NEMA 5-20R

Connected load

1,800 W (approx. 15 A draw)

Data / network

None. Bluetooth audio pairs to the client's phone.

Ventilation

Room must be vacatable and ventilated for 30 min after each ozone cycle

Consumables

Disposable waterproof non-woven liners, one per client

Lead time

90–120 days to your door, made to order — varies by unit

Plumbing

None required

White glove install

$8,000, required — includes hands-on staff training

The manufacturer excludes the following groups from use. Screen every client before a session. This is not medical advice and Vantis makes no health claims.

• Anyone under 18 or over 70
• Pregnancy, nursing under three months, or menstruation
• Implanted metal hardware — plates, pins, stents, cardiac or cerebral
• Pacemakers or any implanted electronic device
• Heart failure or known cardiac insufficiency
• Uncontrolled high blood pressure (above 160/90 mmHg) or low blood pressure (below 60 mmHg diastolic)
• Hyperthyroidism
• Respiratory conditions including asthma, pneumonia or embolism
• Kidney failure, dialysis, or malignancy
• Epilepsy or a diagnosed mental-health condition affected by sensory stimulus
• Open wounds, active skin disease or communicable infection
• Diabetes with blood glucose below 5.0 mmol/L
• Known sensitivity to magnetic or negative-potential fields
• Anyone acutely unwell or within three days of surgery

White label branding

Your logo and business name applied to the capsule, with custom colors and finishes — extra fee

Quoted

Custom shell finish

Matched panel color from the standard range

Quoted

Liner supply program

Standing shipment of disposable waterproof non-woven liners

Quoted

Spare emitter and mat kit

Backup far-infrared emitter set and terahertz back mat held on site

Quoted

• White glove install and hands-on staff training, $8,000 — required on every unit, not optional
• All eleven modalities as standard — nothing on the panel is an upcharge
• Terahertz back mat with jade and bian-stone inlay
• Bluetooth cabin audio and on-board ozone sanitation
• Freight to the loading dock and inside delivery to the installed room
• Four hours of operator training for your staff
• Full spec, site requirement, operating and client-screening documentation before purchase
• Five-year cabinet warranty, three years on thermal and control systems

Complete specification, site drawings and electrical requirements for the AV-FLT-1. From $52,000.